Laser Marker related introduction

In the range of 1% to 100%, the adjustment range is 1%. The advanced motion control system of the Hamm machine allows you to still get ultra-fine engraving quality when engraving at high speed. For a specific engraving speed, the greater the intensity, the greater the depth of cutting or engraving. You can use the Laser Marker panel to adjust the intensity, or you can use the computer's print driver to adjust.

Dot matrix engraving resembles high-definition dot matrix printing. The laser head of the Laser Marker swings left and right to engrave a line consisting of a series of dots each time, and then the laser head moves up and down to engrave multiple lines at the same time, and finally constitutes a full-page image or text. The scanned graphics, text and vectorized graphics can all be engraved by dot matrix.

The size of the laser beam spot can be adjusted with lenses with different focal lengths, and the small spot lens is used for high-resolution engraving. A lens with a large spot is used for lower resolution engraving, but it is the best choice for vector cutting. The standard configuration of the new device is a 2.0-inch lens. The spot size is in the middle, which is suitable for various occasions.